A smooth frequency response gives the YSM2P-II ample source representation without equalization. A precisely tuned active crossover enables each driver to take advantage of the bi-amplification. ¼-inch or XLR input jacks allow for maximum versatility.
The input, located at the rear of the enclosure, accepts line-level signal only (not speaker level). It is ideal to use balanced, shielded cables with a ¼-inch (TRS) or XLR connector however unbalanced 1/4-inch jacks can also be used. Each YSM2P-II should be connected to a single line-level source (e.g., the Right or Left line output from a mixer or preamp). If you want to use multiple YSM2Ps, they can be interconnected using "Y" adaptors.
The Input Trim control allows you to adjust the volume of each monitor until the desired sound level and Left/Right (or Front/Rear) balance is achieved. If clipping distortion becomes audible, reduce the Input Trim level. If more signal reduction is needed, lower your line level from the source with the mixer's master level controls.
Shielded drivers ensure the YSM2P-II's can be located close to computer and video monitors or hard drive recording systems.
The YSM2P-II uses a bi-amplification system with separate power amps for the tweeter and the woofer The YSM2P-II utilizes an electronically active crossover network tuned specifically for each driver. This type of crossover network divides the signal much more precisely than traditional passive crossover networks.
A smooth frequency response gives the YSM2P-II ample source representation without equalization. A precisely tuned active crossover enables each driver to take advantage of the bi-amplification. ¼-inch or XLR input jacks allow for maximum versatility.
The input, located at the rear of the enclosure, accepts line-level signal only (not speaker level). It is ideal to use balanced, shielded cables with a ¼-inch (TRS) or XLR connector however unbalanced 1/4-inch jacks can also be used. Each YSM2P-II should be connected to a single line-level source (e.g., the Right or Left line output from a mixer or preamp). If you want to use multiple YSM2Ps, they can be interconnected using "Y" adaptors.
The Input Trim control allows you to adjust the volume of each monitor until the desired sound level and Left/Right (or Front/Rear) balance is achieved. If clipping distortion becomes audible, reduce the Input Trim level. If more signal reduction is needed, lower your line level from the source with the mixer's master level controls.
Shielded drivers ensure the YSM2P-II's can be located close to computer and video monitors or hard drive recording systems.
The YSM2P-II uses a bi-amplification system with separate power amps for the tweeter and the woofer The YSM2P-II utilizes an electronically active crossover network tuned specifically for each driver. This type of crossover network divides the signal much more precisely than traditional passive crossover networks.